• Optimal driver view
• At the same time the driver is significantly relieved.
• 155° / 140º hydraulic arm slew power-operation.
• Load Sensing hydraulic-system.
Verge mower for tractor
GreenTec offers a complete series of Spearhead combi mounted verge mowers. The various attachment tools make Twiga Combi suitable for cutting and trimming hedges, ditches and verges.
Twiga Combi is an all-round reach mower with a horizontal reach from 5.6 to 7.2 m in a combi mount. The arm is mounted in front or side of the tractor with the pump station in the back.
|Horizontal reach*||6.3 m||7.2 m|
|Vertical reach||7.2 m||8.1 m|
|Transport width||2.2 m||2.2 m|
|Weight without tool||1,300 kg||1,440 kg|
|Minimum tractor size||5,500 kg||6,000 kg|
* Reach varies depending on attachment tool
|Danfoss electric proportional joystick|
|80 hp Danfoss Load Sensing hydraulic system with oil cooler|
|Mechanical parallel arm geometry with APS|
|155° / 140º hydraulic turn of arm with power operation|
|220 l hydraulic oil|
|Dual oil flow control - switch oil flow for different working tools|
|Float head angle|
Cut and pulverize in a single pass, with a working width of 2.3 m
Cut and chop in a single pass, with a working width of 1.6 m
Quadsaw with a working width of 1.6 m
Quadsaw with a working width of 2 m.
Quadsaw with a working width of 2.4 m
Extremely powerful and effective heavy duty cutterbar for hedge cutting
Heavy duty cutterbar for hedge cutting
Cutterbar for maintenance of hedges and fences
For extreme conditions where there are large stumps, rocks or the like
Perfect cutting results and low maintenance costs.
For crushing of scrub, hedges, branches, ect.
Effective cleaning of tiles, asphalt and paving stones
For cleaning of small ditches and streams
Used for raking together, cut grass at waterbeds, streams, ect.
Used for grass mowing in "hard to reach" areas
Twiga COMBI Front:
Tank and oil pump is mounted in three-point back, the arm is mounted on the front plate or front lift. Mounting and dismounting of the entire machine in a short time.
Twiga COMBI Middle:
Tank and oil pump is mounted in three-point back, the arm is mounted between the tractors wheels. Mounting and dismounting of the entire machine in a short time. P
Twiga COMBI Middle and Front
Mechanical parallel arm is standard on the Twiga Combi. This makes operating the machine a lot easier, changing the arm reach is done by working just one valve.
The build of the arm:
With special focus on material use the arm is build in 6/8 mm spring steel. In areas where more strength is needed, the arm is more heavily built. Along the arms length extra segments are welded on and inside reinforcements to prevent any wrenching.
Floats (extra equipment)
For verge mowing float on arm and head is highly recommended. It is better for the driver and you avoid unnecessary wear.
Autopilot (extra equipment) (automatic height regulation):
Autopilot controls the automatic height regulation. A parallelogram between the flailhead and the arm gives a signal to the arms operation-valve which immediately raises or lowers the arm compared to the grounds contours. In the autopilots parallelogram is there incorporated a adjustable spring which carry a part of the flailheads weight. It is possible to regulate the weight on the support-cylinder which then always will be the same. The autopilot gives a big capacity increase, reduced maintenance coats and makes it a lot easier for the driver.